When you’ve read the manufacturer’s instructions and have the tools you’ll need, it’s time to get your hands dirty and understand how to install a kitchen sink or do a repiping service. Check out our step-by-step and resolve this issue.

Step 1: Removal And Marking

With the manual read, you should already have a basis for installing a kitchen sink. Before starting, we indicate that you mark with a pencil where the current sink is located to have a parameter when installing your new furniture.

The time has come to mark the exact place where you want the new sink to be positioned. At this time, you may notice that the new sink may not fit perfectly in place of the old one, and if it happens to be larger, you will need to draw a line (on the new sink) indicating where the stone or joinery will be cut.

Once this is done, you can start to remove the old sink. Empty the cabinet (if any), disconnect electrical accessories, and turn off the registry. Then it is necessary to release the part that holds the tube connected to the sink drain. Do this with the aid of a wrench or pliers. When it is loose, do not pull it at once, as it is necessary to loosen the nut on the opposite side of the hydraulic siphon, which is usually a very curved pipe.

With a stylus, carefully cut the applied sealant to fix the sink on the countertop. If you want to reuse or sell a sink, double your attention, taking care not to cut the surface. Then, carefully push the sink from the bottom upwards so that it comes free. If the model is mounted under the bench, it will be necessary for someone else to hold it while you cut the insulation.

As for the hydraulic part, close the water outlet of the place where you will do the installation. You can now remove the old siphon. Clean the place where the replacement will be carried out with a damp cloth, not forgetting the sink’s outlet.

Step 2: Cut

In some situations, the sink’s surface is made of stone, and you may need to cut it. If this is the case, the next step is to put adhesive tape to protect the support base where the sink will be cut to prevent scratches or even more significant damage during cutting; with the base adequately protected, cut the surface carefully, avoiding as much as possible to leave the marked line.

Fit the new sink in the desired place and see if the new measures are in agreement. If so, we can proceed to the next step. Otherwise, it will be necessary to repeat the marking and cutting steps. When everything is correct, the most complex part of your kitchen sink installation has already been completed. However, it is advisable to request the help of professionals like climate control experts plumbing amongst other to do the work.

Paul Petersen